164
SVGm
Instruction Manual
ENGLISH
Table 23 (Cont.): Warnings messages.
Alarm and event messages
CAN Comms loss
(2)
Descripción Failure in communication between devices.
Acción
correctora
The master/slave configuration requires at least one master, one slave, and a termination resistor.
Check that these requirements are met. Check the wiring
Modulation loss
Description SVGm cannot generate the expected current waveform.
Corrective
action
Check connections. If it continues, contact the technical service.
(2)
Warning messages available with software versions DSP ≥ 1.61 and HDMI ≥ 1.2006.
6.9.- TEMPERATURE
Note: This screen is not visible on the “slave” devices.
In this screen, Figure 51, displays the device’s temperature range for inductor and IGBTs.
Figure 51: Temperature.
The screen displays:
Ok, correct temperature.
High, high temperature.
Low, low temperature.
Use the and keys to navigate through the different display screens.
To Next Page
Loading...