199
Instruction Manual
SVGm
ENGLISH
4
4
Figure 87: SVGm type Rack Change of cooling fans (Step 4).
Remove the 4 screws from the board bracket and carefully disassemble the boards. Remove the
wall grommet from the fan cables to allow disassembly.
4
Remove the screws from the driver board.
25
emove the driver board by gently pulling upwards.
Remove the screws from the bars ( 5), along with the screws in the end of the inductance.
(type 5 and 10mm).
5
8
8
6
Figure 88: SVGm type Rack Change of cooling fans (Step 5, 6, 8).
Remove the 3 screws from the fans.
4
To Next Page
Loading...