6-17
User Guide for Cisco Secure ACS for Windows Server
78-16592-01
Chapter 6 User Group Management
Configuration-specific User Group Settings
• To cause specific protocol attributes to appear on a group profile page, you
must enable the display of those attributes in the Interface Configuration
section of the HTML interface. For more information, see Protocol
Configuration Options for TACACS+, page 3-7, or Protocol Configuration
Options for RADIUS, page 3-11.
This section contains the following topics:
• Setting Token Card Settings for a User Group, page 6-18
• Setting Enable Privilege Options for a User Group, page 6-19
• Enabling Password Aging for the CiscoSecure User Database, page 6-21
• Enabling Password Aging for Users in Windows Databases, page 6-26
• Setting IP Address Assignment Method for a User Group, page 6-28
• Assigning a Downloadable IP ACL to a Group, page 6-30
• Configuring TACACS+ Settings for a User Group, page 6-31
• Configuring a Shell Command Authorization Set for a User Group, page 6-33
• Configuring a PIX Command Authorization Set for a User Group, page 6-35
• Configuring Device-Management Command Authorization for a User Group,
page 6-37
• Configuring IETF RADIUS Settings for a User Group, page 6-38
• Configuring Cisco IOS/PIX RADIUS Settings for a User Group, page 6-40
• Configuring Cisco Aironet RADIUS Settings for a User Group, page 6-41
• Configuring Ascend RADIUS Settings for a User Group, page 6-43
• Configuring Cisco VPN 3000 Concentrator RADIUS Settings for a User
Group, page 6-44
• Configuring Cisco VPN 5000 Concentrator RADIUS Settings for a User
Group, page 6-46
• Configuring Microsoft RADIUS Settings for a User Group, page 6-47
• Configuring Nortel RADIUS Settings for a User Group, page 6-49
• Configuring Juniper RADIUS Settings for a User Group, page 6-50
• Configuring BBSM RADIUS Settings for a User Group, page 6-51
• Configuring Custom RADIUS VSA Settings for a User Group, page 6-53
To Next Page
Loading...
Need help?
General