Chapter 7 User Management
User Management
7-54
User Guide for Cisco Secure ACS for Windows Server
78-16592-01
To configure and enable custom RADIUS attributes to be applied as an
authorization for the current user, follow these steps:
Step 1 Perform Step 1 through Step 3 of Adding a Basic User Account, page 7-4.
The User Setup Edit page opens. The username being added or edited is at the top
of the page.
Step 2 Before configuring custom RADIUS attributes, be sure your IETF RADIUS
attributes are configured properly. For more information about setting IETF
RADIUS attributes, see Setting IETF RADIUS Parameters for a User, page 7-38.
Step 3 In the RADIUS custom name Attributes table, to specify the attributes that should
be authorized for the user, follow these steps:
a. Select the check box next to the particular attribute.
b. Further define the authorization for that attribute in the box next to it, as
required.
c. Continue to select and define attributes, as applicable.
For more information about attributes, see Appendix C, “RADIUS
Attributes”, or your AAA client documentation.
Step 4 Do one of the following:
• If you are finished configuring the user account options, click Submit to
record the options.
• To continue to specify the user account options, perform other procedures in
this chapter, as applicable.
User Management
This section describes how to use the User Setup section to perform a variety of
user account managerial tasks.
This section contains the following topics:
• Listing All Users, page 7-55
• Finding a User, page 7-55
• Disabling a User Account, page 7-56
To Next Page
Loading...
Need help?
General