2-88
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
SPANTREE_FAST Messages
SPANTREE_FAST Messages
This section contains the spanning-tree fast-convergence message.
Error Message SPANTREE_FAST-7-PORT_FWD_UPLINK: [chars] [chars] moved to Forwarding
(UplinkFast).
Explanation The listed interface has been selected as the new path to the root switch for the listed
spanning-tree instance. The first [chars] is the spanning-tree instance, and the second [chars] is the
interface.
Recommended Action No action is required.
SPANTREE_VLAN_SW Messages
The section contains the per-VLAN spanning-tree-specific message.
Error Message SPANTREE_VLAN_SW-2-MAX_INSTANCE: Platform limit of [dec] STP instances
exceeded. No instance created for [chars] (port [chars]).
Explanation The number of currently active VLAN spanning-tree instances has reached a
platform-specific limit. No additional VLAN instances will be created until the number of existing
instances drops below the platform limit. [dec] is the spanning-tree instance limit, and the first
[chars] is the smallest VLAN ID of those VLANs that are unable to have spanning-tree instances
created.
Recommended Action Reduce the number of currently active spanning-tree instances by either
disabling some of the currently active spanning-tree instances or deleting the VLANs associated
with them. You must manually enable the spanning trees that could not be created because of limited
instances.
To Next Page
Loading...
Need help?
General