2-50
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
PLATFORM_HCEF Message
Error Message PLATFORM_FBM-4-RESOURCE_CRUNCH: Fallback bridging on bridge-group
[dec] is experiencing a resource crunch. One or more bridge-groups may not be
functional. It will recover automatically when system recovers from resource
crunch. Delete the bridge-group to immediately recover.
Explanation Fallback bridging could not be properly configured. The most likely cause is a
hardware-full condition on at least one stack member.
Recommended Action The switch automatically recovers, but this could take some time. For an
immediate recovery, use the shutdown interface configuration command to disable the port and to
stop the traffic flow to the switch. Use the clear mac-address-table dynamic privileged EXEC
command to remove all MAC addresses from the hardware. Use the no shutdown interface
configuration command to re-enable the port.
PLATFORM_HCEF Message
This section has the Cisco Express Forwarding message.
Error Message PLATFORM_HCEF-3-ADJ: [chars]
Note This message applies only to the Catalyst Switch Module 3110.
Explanation This message appears when an unsupported feature is configured on a switch running
Cisco IOS Release 12.2(25)SE. [chars] is the error message.
Recommended Action Determine if a generic routing encapsulation (GRE) tunnel or the ip cef
accounting global configuration command are configured. Only Distance Vector Multicast Routing
Protocol (DVMRP) tunnels are supported. If the GRE tunnel is configured, remove the tunnel, or
upgrade the switch software to a Cisco IOS release when the GRE feature is needed. If the ip cef
accounting command is configured, remove it by using the no ip cef accounting global
configuration command.
PLATFORM_HPLM Messages
This section has the platform pseudo label manager messages.
Error Message PLATFORM_HPLM-3-ERROR: Failed Alloc for xaction record label move from
[dec] to [dec].
Explanation An internal resource allocation error occurred during the label compaction process. The
first [dec] is the previous label, and the second [dec] is the new label.
Recommended Action Copy the error message exactly as it appears on the console or in the system
log, call your IBM technical support representative, and provide the representative with the gathered
information.
To Next Page
Loading...
Need help?
General