2-15
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
DHCP_SNOOPING Messages
Error Message CLS_ACC-7-ACC_VLAN: Selected vlan [dec] for consoleless access
Explanation The switch assigned a VLAN to the management interface for consoleless access. [dec]
is the VLAN ID.
Recommended Action No action is required.
Error Message CLS_ACC-7-CONFIG: Save access intf config: if: [chars], port num:
[dec], vlan [dec], admin-down?:[dec]
Explanation The switch has saved the interface configuration. After the switch exits Express Setup
mode and the management interface is configured, the saved configuration takes effect. [chars] is
the name of the mode. The first [dec] is the port number, the second [dec] is the VLAN ID, and the
third [dec] is the port status.
Recommended Action No action is required.
Error Message CLS_ACC-7-CONFIG_SUCCESS: [chars]
Explanation The management interface has been configured, or its original configuration has been
restored. [chars] is the name of the configuration file.
Recommended Action No action is required.
DHCP_SNOOPING Messages
This section contains the DHCP snooping messages.
Error Message DHCP_SNOOPING-3-DHCP_SNOOPING_INTERNAL_ERROR: DHCP Snooping internal
error, [chars].
Explanation A software sanity check failed in the DHCP snooping process. [chars] is the error.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
“Error Message Traceback Reports” section on page 1-6.
Error Message DHCP_SNOOPING-4-AGENT_OPERATION_FAILED: DHCP snooping binding
transfer failed. [chars].
Explanation The DHCP snooping binding transfer process failed because of the specified reason for
failure. [chars] is the reason for failure.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General