2-7
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
BACKUP_INTERFACE Messages
Error Message ACLMGR-3-UNLOADING: Unloading [chars] label [dec] feature.
Explanation The ACL manager was unable to fit the complete configuration into the hardware, so
some features will be applied in software. This prevents some or all of the packets in a VLAN from
being forwarded in hardware and requires them to be forwarded by the CPU. Multicast packets
might be dropped entirely instead of being forwarded. [chars] is the direction (input or output), and
[dec] is the label number.
Recommended Action Use a simpler configuration. Use the same ACLs on multiple interfaces, if
possible.
BACKUP_INTERFACE Messages
This section contains the Flex Link messages.
Error Message BACKUP_INTERFACE-5-PREEMPT: Preempting interface [chars] in backup
pair ([chars], [chars]), preemption mode is [chars]
Explanation The switch is preempting the current forwarding interface in the backup interface pair.
The first [chars] is the number of the current forwarding interface. The second and third [chars] are
the names of the interfaces in the backup pair, and the fourth [chars] is the pre-preemption mode.
Recommended Action No action is required.
Error Message BACKUP_INTERFACE-5-VLB_NON_TRUNK: Warning: Flexlink VLB is not
allowed on non-trunk ports. Please configure [chars] to be a trunk port.
Explanation Flex Link VLB detects a nontrunk port. [chars] is the interface name.
Recommended Action Configure the interface to operate in trunking mode.
BADTRANSCEIVER Messages
This section contains the BADTRANSCEIVER message.
Error Message BADTRANSCEIVER, PHY, LOG_WARNING: An innapropriate transceiver has
been inserted in interface [chars].
Note This message applies only to the Catalyst Switch Module 3110.
Explanation A defective module is installed in the specified interface. [chars] is the interface.
Recommended Action Remove the transceiver. If it was purchased from Cisco, contact your Cisco
representative to have the transceiver replaced.
To Next Page
Loading...
Need help?
General