EasyManuals Logo

Cisco 3110 User Manual

Cisco 3110
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
2-3
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
ACLMGR Messages
UFAST_MCAST_SW Messages, page 2-109
VQPCLIENT Messages, page 2-109
WCCP Messages, page 2-112
ACLMGR Messages
This section contains the access control list (ACL) manager messages. Most messages in this section are
the result of a switch memory shortage, which includes hardware memory and label space but not CPU
memory. Both kinds of memory shortages are described.
Error Message ACLMGR-2-NOMAP: Cannot create ACL Manager data structures for VLAN Map
[chars].
Explanation The ACL manager could not allocate the data structures needed to describe a VLAN
map in a form that can be loaded into hardware. This error is most likely caused by lack of free
memory. [chars] is the VLAN map name.
Recommended Action Reduce other system activity to ease memory demands.
Error Message ACLMGR-2-NOVLB: Cannot create memory block for VLAN [dec].
Explanation The ACL manager could not save per-VLAN information needed for its correct
operation. Some per-interface features, such as access groups or VLAN maps, will not be configured
correctly. [dec] is the VLAN ID.
Recommended Action Use a less complicated configuration that requires less memory.
Error Message ACLMGR-2-NOVMR: Cannot create VMR data structures for access list
[chars].
Explanation The ACL manager was unable to allocate the value-mask result (VMR) data structures
needed to describe an ACL in a form that can be loaded into hardware. This error is most likely
caused by lack of available memory. [chars] is the access-list name.
Recommended Action Use a less complicated configuration that requires less memory.
Error Message ACLMGR-3-ACLTCAMFULL: Acl Tcam Full. Drop packets on Output Acl label
[dec] on [chars] [chars].
Explanation There are too many ACLs configured for the platform-specific ACL hardware table to
support. [dec] is the label number, and [chars] is the layer. The first [chars] is for Layer 3; the second
is for Layer 2. If only the Layer 2 or Later 3 hardware table is full, only one string appears, and the
other string is
NULL.
Recommended Action Reduce the number of IP or MAC access lists to be applied to interfaces.

Table of Contents

Other manuals for Cisco 3110

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3110 and is the answer not in the manual?

Cisco 3110 Specifications

General IconGeneral
BrandCisco
Model3110
CategoryFirewall
LanguageEnglish

Related product manuals