Cisco 3110 User Manual

1-4
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 1 System Message Overview
How to Read System Messages
• SEVERITY is a single-digit code from 0 to 7 that reflects the severity of the condition. The lower
the number, the more serious the situation.
Table 1-2 lists the message severity levels.
• MNEMONIC is a code that uniquely identifies the message.
STACKMGR Stack manager (only the Catalyst
Switch Module 3110)
“STACKMGR Messages” section on page 2-89
STORM_CONTROL Storm control “STORM_CONTROL Messages” section on
page 2-92
SUPERVISOR Supervisor ASIC “SUPERVISOR Messages” section on page 2-92
SUPQ Supervisor queue “SUPQ Messages” section on page 2-93
SW_DAI Dynamic ARP inspection “SW_DAI Messages” section on page 2-94
SW_MACAUTH MAC address authentication “SW_MACAUTH Messages” section on
page 2-97
SW_QOS_TB QoS trusted boundary “SWITCH_QOS_TB Messages” section on
page 2-98
SW_VLAN VLAN manager “SW_VLAN Messages” section on page 2-98
TCAMMGR Ternary content addressable memory
manager
“TCAMMGR Messages” section on page 2-105
UDLD UniDirectional Link Detection “UDLD Messages” section on page 2-107
UFAST_MCAST_SW UplinkFast packet transmission “UFAST_MCAST_SW Messages” section on
page 2-109
VQPCLIENT VLAN Query Protocol client “VQPCLIENT Messages” section on page 2-109
WCCP Web Cache Communication Protocol
(WCCP)
“WCCP Messages” section on page 2-112
Table 1-1 Facility Codes (continued)
Facility Code Description Location
Ta b l e 1-2 Message Severity Levels
Severity Level Description
0 – emergency System is unusable.
1 – alert Immediate action required.
2 – critical Critical condition.
3 – error Error condition.
4 – warning Warning condition.
5 – notification Normal but significant condition.
6 – informational Informational message only.
7 – debugging Message that appears during debugging only.

Cisco 3110 Specifications

General

Brand	Cisco
Model	3110
Category	Firewall
Language	English