2-18
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
DOT1X Messages
Error Message DHCP_SNOOPING-6-INTERFACE_NOT_VALID: Interface not valid. [dec]
bindings ignored.
Explanation The specified number of bindings were ignored when the switch read the database file
because the interface in binding database is not available, the interface is a routed port, or the
interface is a DHCP snooping-trusted Layer 2 interface. [dec] is the number of bindings that the
switch ignores.
Recommended Action No action is required.
Error Message DHCP_SNOOPING-6-LEASE_EXPIRED: Lease Expired. [dec] bindings ignored.
Explanation The specified number of bindings were ignored when the switch read the database file
because the DHCP lease expired. [dec] is the number of bindings.
Recommended Action No action is required.
Error Message DHCP_SNOOPING-6-PARSE_FAILURE: Parsing failed for [dec] bindings.
Explanation The specified number of bindings were ignored when the switch read the database file
because the database read operation failed. [dec] is the number of bindings.
Recommended Action No action is required.
Error Message DHCP_SNOOPING-6-VLAN_NOT_SUPPORTED: Vlan not supported. [dec] bindings
ignored.
Explanation The specified number of bindings were ignored when the switch read the database file
because the VLAN is no longer configured on the switch. [dec] is the number of bindings that the
switch ignores.
Recommended Action No action required.
DOT1X Messages
This section contains the IEEE 802.1x messages.
Error Message DOT1X-4-MEM_UNAVAIL: Memory was not available to perform the
802.1X
action.
Explanation The system memory is not sufficient to perform IEEE 802.1x authentication.
Recommended Action Reduce other system activity to reduce memory demands. If the switch does
not have enough memory, upgrade to a larger memory configuration.
To Next Page
Loading...
Need help?
General