2-37
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
GBIC_SECURITY_UNIQUE Messages
GBIC_SECURITY_UNIQUE Messages
This section contains the 10-Gigabit Ethernet module security messages that identify whether the
module is unique.
Note The Catalyst Switch Module 3110X supports only 10-Gigabit Ethernet modules and do not support
GBIC modules. Although the error message text refers to GBIC interfaces and modules, the messages
from the switch actually refer to the 10-Gigabit Ethernet module interfaces and modules.
Error Message GBIC_SECURITY_UNIQUE-3-DUPLICATE_GBIC: GBIC interface [dec]/[dec] is
a duplicate of GBIC interface [dec]/[dec].
Note This message applies only to the Catalyst Switch Module 3110X.
Explanation The SFP module was identified as a Cisco GBIC or SFP module, but its vendor ID and
serial number match that of another interface on the system. The first [dec]/[dec] is the interface of
the duplicate GBIC or SPF module, and the second [dec]/[dec] is the interface of the existing
module.
Recommended Action Cisco GBIC or SFP modules are assigned unique serial numbers. Verify that
the module was obtained from Cisco or from a supported vendor.
Error Message GBIC_SECURITY_UNIQUE-4-DUPLICATE_SN: GBIC interface [dec]/[dec] has
the same serial number as another GBIC interface.
Note This message applies only to the Catalyst Switch Module 3110X.
Explanation The SFP module was identified as a Cisco SFP module, but its serial number matches
that of another interface on the system. [dec]/[dec] is the interface in which the duplicate module is
installed.
Recommended Action Cisco SFP modules are assigned unique serial numbers. Verify that the module
was obtained from Cisco or from a supported vendor.
To Next Page
Loading...
Need help?
General