2-42
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
IGMP_QUERIER Messages
IGMP_QUERIER Messages
This section contains the IGMP querier messages.
Error Message IGMP_QUERIER-4-NO_IP_ADDR_CFG: The IGMP querier cannot send out
General Query messages in VLAN [dec] because there is no IP address configured on
the system.
Explanation You must specify an IP address for the IGMP querier at either the global or per-VLAN
level. [dec] is the VLAN ID.
Recommended Action Configure a source IP address for the IGMP querier.
Error Message IGMP_QUERIER-4-PIM_ENABLED: The IGMP querier is operationally disabled
in VLAN [dec] because PIM has been enabled on the SVI.
Explanation PIM was detected on the SVI. Do not enable the IGMP querier when PIM is enabled on
the SVI. [dec] is the VLAN ID.
Recommended Action Ensure that PIM is disabled on the SVI.
Error Message IGMP_QUERIER-4-SNOOPING_DISABLED: The IGMP querier is operationally
disabled in VLAN [dec] because IGMP snooping has been disabled in this VLAN.
Explanation IGMP snooping is disabled on this VLAN. Do not enable the IGMP querier when IGMP
snooping is disabled. [dec] is the VLAN IDs.
Recommended Action Confirm that IGMP snooping is enabled both globally and on the VLAN.
Error Message IGMP_QUERIER-6-PIM_DISABLED: The IGMP querier is now operationally
enabled in VLAN [dec] because PIM is no longer enabled on the SVI.
Explanation Protocol-Independent Multicast (PIM) is disabled on the switch virtual interface (SVI),
and the IGMP querier function is now enabled. [dec] is the VLAN ID.
Recommended Action No action is required.
Error Message IGMP_QUERIER-6-SNOOPING_ENABLED: The IGMP querier is now operationally
enabled in VLAN [dec] because IGMP snooping is no longer disabled.
Explanation IGMP snooping was enabled. As a result, the IGMP querier function is now enabled.
[dec] is the VLAN ID.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General