Name: Cisco 3110
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

2-36

Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide

OL-12191-01

Chapter 2 Message and Recovery Procedures

GBIC_SECURITY_CRYPT Messages

This section contains the 10-Gigabit Ethernet module security messages. The switch recognizes the

module as a Cisco module but identifies another problem with it.

Note The Catalyst Switch Module 3110X supports 10-Gigabit Ethernet modules but do not support GBIC

modules. Although the error message text refers to GBIC interfaces and modules, the messages from the

switch actually refer to the 10-Gigabit Ethernet module interfaces and modules.

Error Message GBIC_SECURITY_CRYPT-4-ID_MISMATCH: Identification check failed for

GBIC in port [chars]

Note This message applies only to the Catalyst Switch Module 3110X.

Explanation The small form-factor pluggable (SFP) module was identified as a Cisco SFP module,

but the system could not verify its identity. [chars] is the port.

Recommended Action Ensure that the Cisco IOS software running on the switch supports the SFP

module. You might need to upgrade your software. Otherwise, verify that the SFP module was

obtained from Cisco or from a supported vendor.

Error Message GBIC_SECURITY_CRYPT-4-UNRECOGNIZED_VENDOR: GBIC in port [chars]

manufactured by an unrecognized vendor

Note This message applies only to the Catalyst Switch Module 3110X.

Explanation The small form-factor pluggable (SFP) module was identified as a Cisco SFP module,

but the switch could not match its manufacturer with one on the known list of Cisco SFP module

vendors. [chars] is the port.

Recommended Action Ensure that the Cisco IOS software running on the switch supports the SFP

module. You might need to upgrade your software.

Error Message GBIC_SECURITY_CRYPT-4-VN_DATA_CRC_ERROR: GBIC in port [chars] has bad

crc

Note This message applies only to the Catalyst Switch Module 3110X.

Explanation The small form-factor pluggable (SFP) module was identified as a Cisco SFP module,

but it does not have a valid cyclic redundancy check (CRC) in the EEPROM data. [chars] is the port.

Recommended Action Ensure that the Cisco IOS software running on the switch supports the SFP

module. You might need to upgrade your software. Even if the SFP module is unrecognized by the

switch, the SFP module might still operate properly but have limited functionality.

Cisco 3110 User Manual

Other manuals for Cisco 3110