2-89
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
STACKMGR Messages
STACKMGR Messages
This section contains stack manager system messages on stacking-capable switches. These messages are
related to the status of switches within the stack.
Error Message STACKMGR-3-HDM_GET_DEVICE_RECORD_FAIL: Device Manager could not get
device record.
Note This message applies only to the Catalyst Switch Module 3110.
Explanation This switch could not get the device record for some or all other switches in the stack.
Recommended Action Find out more about the error by using the show tech-support privileged EXEC
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting IBM, see the
“Error Message Traceback
Reports” section on page 1-6.
Error Message STACKMGR-3-MSG_FAIL: Failed to retrieve stack message from port-asic
[dec] in direction [dec].
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The stack manager module failed to retrieve stack messages. The first [dec] is the ASIC
ID, and the second [dec] is the direction.
Recommended Action No action is required.
Error Message STACKMGR-3-NORECORD: Switch removed event for switch [dec] with no
switch record.
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The stack manager received a switch-removed event for which there is no switch record.
[dec] is the switch number.
Recommended Action No action is required.
To Next Page
Loading...
Need help?
General