2-58
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
PLATFORM_SPAN Messages
Error Message PLATFORM_RPC-3-UNABLE_TO_SEND: System is unable to send RPC message:
[chars], paks_outstanding: [int].
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The system had a low-level transport failure when trying to send an RPC message.
[chars] is a description of the error returned by the low-level packet sending driver that triggered the
error (usually one of these: fifo full, fifo empty, out of buf, out of mem, null pointer, misc failure),
and [int] is the number of packets outstanding (packets from the RPC code to the driver that have
not yet been sent).
Recommended Action Find out more about the error by using the show tech-support privileged EXEC
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting IBM, see the
“Error Message Traceback
Reports” section on page 1-6.
PLATFORM_SPAN Messages
This section contains the Switched Port Analyzer (SPAN) messages.
Error Message PLATFORM_SPAN-3-PACKET_DROP: Decreases egress SPAN rate.
Explanation Egress SPAN rates are falling because SPAN is enabled with multicast routing or
fallback bridging.
Recommended Action Find out more about the error by using the show tech-support privileged EXEC
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting IBM, see the
“Error Message Traceback
Reports” section on page 1-6.
PLATFORM_UCAST Messages
This section contains platform unicast routing messages.
Error Message PLATFORM_UCAST-3-ADJ: [chars].
Explanation The adjacency module for unicast routing encountered an error. [chars] describes the
error.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
“Error Message Traceback Reports” section on page 1-6.
To Next Page
Loading...
