2-44
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
IP_DEVICE_TRACKING Messages
Error Message IMAGEMGR-6-AUTO_COPY_SW: [chars].
Note This message applies only to the Catalyst Switch Module 3110.
Explanation A line of output from the auto-copy-software process appears. [chars] is a text message
reporting status of the upgrade process.
Recommended Action No action is required.
Error Message IMAGEMGR-6-AUTO_DOWNLOAD_SW_INITIATED: Auto-download-software process
initiated for systems [bits: [hex]].
Note This message applies only to the Catalyst Switch Module 3110.
Explanation Systems with incompatible software have been detected in the switch stack. The stack
now attempts to download software from a previously configured location and to install it to make
the systems compatible. [bits [hex]] is the bit representation of the switch number.
Recommended Action No action is required.
Error Message IMAGEMGR-6-AUTO_DOWNLOAD_SW: [chars].
Note This message applies only to the Catalyst Switch Module 3110.
Explanation A line of output from the auto-download-software process appears [chars] is a text
message reporting the status of the upgrade process.
Recommended Action No action is required.
IP_DEVICE_TRACKING Messages
This section contains the IP Device Tracking message.
Error Message IP_DEVICE_TRACKING-4-TABLE_LOCK_FAILED: Table already locked by
process-id [dec]([chars])
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The IP device tracking table could not be updated due to a lock held by another process.
[dec] is the process number, and [chars] is the process.
Recommended Action No action is required.