2-62
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
PLATFORM_WCCP Messages
PLATFORM_WCCP Messages
This section contains platform Web Cache Communication Protocol (WCCP) messages.
Error Message PLATFORM-WCCP-3-NO_LABEL: Cannot allocate WCCP Label
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The WCCP label could not be allocated. This means that the hardware cannot be
programmed to implement WCCP redirection.
Recommended Action Reduce the number of interfaces configured for WCCP redirection or policy
based routing.
Error Message PLATFORM-WCCP-4-SDM_MISMATCH: WCCP requires sdm template routing
Note This message applies only to the Catalyst Switch Module 3110.
Explanation To support this feature, you need to enable the Switch Database Management (SDM)
routing template.
Recommended Action Modify the SDM template to enable the routing template. Use the sdm prefer
routing global configuration command, and then reload the switch by using the reload privileged
EXEC command.
PM Messages
This section contains the port manager messages. The port manager is a state machine that controls all
the logical and physical interfaces. All features, such as VLANs, UDLD, and so forth, work with the port
manager to provide switch functions.
Error Message PM-2-LOW_SP_MEM: Switch process available memory is less than [dec]
bytes.
Explanation The available memory for the switch processor is low. This can occur when too many
Layer 2 VLANs are configured. [dec] is the available memory.
Recommended Action Remove features from the system to reduce memory usage.
To Next Page
Loading...
Need help?
General