2-105
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
TCAMMGR Messages
Error Message SW_VLAN-6-VTP_MODE_CHANGE: VLAN manager changing device mode from
[chars] to [chars].
Explanation An automatic VTP mode device change occurred upon receipt of a VLAN configuration
database message containing more than a set number of VLANs. The first [chars] is the previous
mode, and the second [chars] is the current mode.
Recommended Action No action is required.
TCAMMGR Messages
This section contains the ternary content-addressable memory manager (TCAMMGR) messages.
Error Message TCAMMGR-3-GROW_ERROR: cam region [dec] can not grow.
Explanation The specified CAM region is configured as a static region with a fixed number of
entries, and a caller requested to add more CAM entries. [dec] is the CAM region.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
“Error Message Traceback Reports” section on page 1-6.
Error Message TCAMMGR-3-HANDLE_ERROR: cam handle [hex] is invalid.
Explanation The CAM handle used by the caller is not valid. [hex] is the handle value.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
“Error Message Traceback Reports” section on page 1-6.
Error Message TCAMMGR-3-INDEX_ERROR: cam value/mask index [dec] is invalid.
Explanation The CAM index used by the caller is not valid. [dec] is the index value.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact IBM technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting IBM, see the
“Error Message Traceback Reports” section on page 1-6.
To Next Page
Loading...
Need help?
General