Cisco 3110 User Manual

2-11
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
CLS_ACC Messages
Error Message CFGMGR-6-UNABLE_TO_NVGEN_BUSY_RUNNING_CFG: config file busy,
retrying...
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The stack master is temporarily unable to generate the stack running configuration
because another process is generating the configuration file.
Recommended Action No action is required. The action will be tried again.
Error Message CFGMGR-6-UNABLE_TO_NVGEN_RUNNING_CFG: config file too large...
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The stack master is unable to generate the stack running configuration because the
configuration file is too large.
Recommended Action Remove some configuration commands.
CLS_ACC Messages
This section contains the Express Setup messages that appear when you use the Ethernet management
port to connect to the PC. In these messages, Express Setup is referred to as consoleless access.
Error Message CLS_ACC-2-CONFIG_NV_DATA: Express setup parameter committed. Default
port role will be applied
Explanation After the Express Setup settings are configured, the switch becomes a configured
switch. The default port roles are automatically applied to all ports. You can now manually modify
the port role configurations.
Recommended Action No action is required.
Error Message CLS_ACC-2-MODE_ENTERED: Entering consoleless access mode [chars]
Explanation The switch enters consoleless access mode. [chars] is the name of the mode.
Recommended Action No action is required.
Error Message CLS_ACC-2-MODE_EXITED: Complete consoleless access from mode [chars]
Explanation The switch exits from consoleless access mode. [chars] is the mode.
Recommended Action No action is required.

Cisco 3110 Specifications

General

Brand	Cisco
Model	3110
Category	Firewall
Language	English