2-90
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
STACKMGR Messages
Error Message STACKMGR-4-MASTER_ELECTED: Switch [dec] has been elected as MASTER of
the stack.
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The specified switch has been elected stack master. [dec] is the switch number of the
elected stack master.
Recommended Action No action is required.
Error Message STACKMGR-4-STACK_LINK_CHANGE: Stack Port [chars] Switch [dec] has
changed to state [chars].
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The specified stack port status has changed state to up or down. The first [chars] is the
stack port (1 or 2), [dec] is the switch number, and the second [chars] is the new state (up or down).
Recommended Action No action is required.
Error Message STACKMGR-4-SWITCH_ADDED: Switch [dec] has been ADDED to the stack.
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The specified stack member switch has been added to the stack. [dec] is the switch
number.
Recommended Action No action is required.
Error Message STACKMGR-4-SWITCH_ADDED_SDM: Switch [dec] has been ADDED to the stack
(SDM_MISMATCH).
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The specified switch has been added to the stack. [dec] is the switch number.
SDM_MISMATCH means that the added switch cannot support the SDM template that the stack
master is using. Subsequent SDM-6-MISMATCH_ADVISE messages explain the mismatch and
recommend corrective actions.
Recommended Action No action is required unless SDM_MISMATCH is displayed. For
SDM_MISMATCH corrective actions, see SDM-6-MISMATCH_ADVISE.
To Next Page
Loading...
