Cisco 3110 - Page 107

2-91
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
STACKMGR Messages
Error Message STACKMGR-4-SWITCH_ADDED_VM: Switch [dec] has been ADDED to the stack
(VERSION_MISMATCH).
Note This message applies only to the Catalyst Switch Module 3110.
Explanation A switch that has been added to the stack has a different software version. [dec] is the
switch number.
Recommended Action No action is required.
Error Message STACKMGR-4-SWITCH_REMOVED: Switch [dec] has been REMOVED from the
stack.
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The specified switch has been removed from the stack. [dec] is the switch number.
Recommended Action No action is required.
Error Message STACKMGR-5-MASTER_READY: Master Switch [dec] is READY.
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The stack master is ready for use. [dec] is the stack master switch number.
Recommended Action No action is required.
Error Message STACKMGR-5-SWITCH_READY: Switch [dec] is READY.
Note This message applies only to the Catalyst Switch Module 3110.
Explanation The switch is ready. [dec] is the switch number.
Recommended Action No action is required.