EasyManuals Logo

Cisco 3110 User Manual

Cisco 3110
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
2-16
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
DHCP_SNOOPING Messages
Error Message DHCP_SNOOPING-4-AGENT_OPERATION_FAILED_N: DHCP snooping binding
transfer failed ([dec]). [chars].
Explanation The DHCP snooping binding transfer process failed because of the specified reason for
failure [dec] is the number of failures, and [chars] is the reason for the failure. This message is
rate-limited.
Recommended Action No action is required.
Error Message DHCP_SNOOPING-4-DHCP_SNOOPING_ERRDISABLE_WARNING: DHCP Snooping
received [dec] DHCP packets on interface [chars].
Explanation The switch detected a DHCP packet rate-limit violation on the specified interface and
put the interface in the error-disabled state. [dec] is the number of DCHP packets, and [chars] is the
interface.
Recommended Action No action is required.
Error Message DHCP_SNOOPING-4-DHCP_SNOOPING_PVLAN_WARNING: DHCP Snooping
configuration may not take effect on secondary vlan [dec]. [chars]
Explanation If the private VLAN feature is configured, the DHCP snooping configuration on the
primary VLAN automatically propagates to all the secondary VLANs. [dec] is the VLAN ID of the
secondary VLAN, and [chars] is the warning.
Recommended Action No action is required.
Error Message DHCP_SNOOPING-4-IP_SOURCE_BINDING_NON_EXISTING_VLAN_WARNING: IP
source binding is configured on non existing vlan [dec].
Explanation The message means that an IP source binding was configured on a VLAN that has not
been configured yet. [dec] is the VLAN.
Recommended Action No action is required.
Error Message DHCP_SNOOPING-4-IP_SOURCE_BINDING_PVLAN_WARNING: IP source filter may
not take effect on secondary vlan [dec] where IP source binding is configured.
[chars].
Explanation If private VLANs are configured, the IP-source-guard filter on the primary VLAN
automatically propagates to all secondary VLANs. [dec] is the secondary VLAN, and [chars] is the
warning.
Recommended Action No action is required.

Table of Contents

Other manuals for Cisco 3110

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3110 and is the answer not in the manual?

Cisco 3110 Specifications

General IconGeneral
BrandCisco
Model3110
CategoryFirewall
LanguageEnglish

Related product manuals