Cisco 3110 User Manual

2-108
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
UDLD Messages
Error Message UDLD-3-UDLD_INTERNAL_IF_ERROR: UDLD internal error, interface [chars]
[chars].
Explanation A software check failed during UDLD processing. The first [chars] is the interface, and
the second [chars] is a description of the error.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
“Error Message Traceback
Reports” section on page 1-6.
Error Message UDLD-4-UDLD_PORT_DISABLED: UDLD disabled interface [chars], [chars]
detected.
Explanation The UDLD Protocol disabled an interface because it detected connections between
neighbors that were functioning only in one direction, which might potentially cause spanning-tree
loops or interfere with connectivity. The cause is likely to be hardware related, either due to a bad
port, a bad cable, or a misconfigured cable. The first [chars] is the interface, and the second [chars]
is the error detected.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact
IBM technical support and provide the representative with the gathered information. For more
information about the online tools and about contacting IBM, see the
“Error Message Traceback
Reports” section on page 1-6.
Error Message UDLD-6-UDLD_PORT_RESET: UDLD reset interface [chars].
Explanation The UDLD Protocol detected a unidirectional connection between neighbors. Reset the
port that was disabled by UDLD by using the udld reset privileged EXEC command or through a
hardware action such as a link-state change. [chars] is the interface.
Recommended Action Find out more about the error by using the show tech-support privileged EXEC
command and by copying the error message exactly as it appears on the console or system log and
entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For
more information about these online tools and about contacting IBM, see the
“Error Message Traceback
Reports” section on page 1-6.

Cisco 3110 Specifications

General

Brand	Cisco
Model	3110
Category	Firewall
Language	English