2-20
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
DOT1X Messages
Error Message DOT1X-5-ERR_PVLAN_EQ_VVLAN: Dot1x can not be enabled on a port with
Access VLAN equal to Voice VLAN.
Explanation IEEE 802.1x authentication could not be enabled on a port with the same VLAN for the
access VLAN and the voice VLAN. This occurred because the switch tried to set IEEE 802.1x port
control to auto or force-unauthorized mode on the port, which is not allowed.
Recommended Action Change the voice VLAN or access VLAN on the interface, and retry the IEEE
802.1x operation.
Error Message DOT1X-5-ERR_RSPAN_VLAN: Dot1x can not be enabled on ports configured
in Remote SPAN vlan.
Explanation IEEE 802.1x authorization could not be enabled on the remote SPAN (RSPAN) VLAN
port. This occurred because the switch tried to set IEEE 802.1x port-control to auto or
force-unauthorized mode on a port assigned to an RSPAN VLAN, which is not allowed.
Recommended Action Disable RSPAN on the VLAN, and retry the IEEE 802.1x operation.
Error Message DOT1X-5-ERR_SPANDST: Dot1x can not be enabled on [chars]. It is
configured as a SPAN Dest port.
Explanation IEEE 802.1x and SPAN destination ports are mutually exclusive. [chars] is the port.
Recommended Action Disable the SPAN destination port configuration, and then reconfigure IEEE
802.1x authentication on the port.
Error Message DOT1X-5-ERR_TRUNK: Dot1x can not be enabled on Trunk port.
Explanation IEEE 802.1x authentication could not be enabled on the trunk port. This occurred
because the switch tried to set IEEE 802.1x port control to auto or force-unauthorized mode on a
trunk port, which is not allowed.
Recommended Action Disable trunking on the interface, and try to re-enable IEEE 802.1x
authentication on the port.
Error Message DOT1X-5-ERR_VLAN_INVALID: The VLAN [dec] is invalid and cannot be
assiged for use on the Dot1x port [chars] Vlan
Explanation The specified VLAN is out of range and cannot be assiged as an IEEE 802.1x port. [dec]
is the VLAN, and [chars] is the IEEE 802.1x port.
Recommended Action Reconfigure the configuration to use a valid VLAN.
To Next Page
Loading...
