2-28
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter System Message Guide
OL-12191-01
Chapter 2 Message and Recovery Procedures
EC Messages
Error Message EC-5-DONTBNDL: [chars] suspended: incompatible remote port with
[chars]
Explanation The configuration of the remote port is different from the configuration of other remote
ports in the bundle. A port can only join the bundle when the configuration of the local port and the
configuration of the remote port are the same as other ports already in the bundle. The first [chars]
is the name of the local interface that is being suspended, and the second [chars] is the name of the
local interface that is already bundled.
Recommended Action Make sure that the configuration of the remote ports is the same for all ports in
the bundle.
Error Message EC-5-ERRPROT: Channel protocol mismatch for interface [chars] in group
[dec]: the interface can not be added to the channel group.
Explanation The interface cannot be added to the channel group with the specified mode. [chars] is
the interface, and [dec] is the channel group.
Recommended Action Change the channel group or the mode for the interface.
Error Message EC-5-ERRPROT2: Command rejected: the interface [chars] is already part
of a channel with a different type of protocol enabled.
Explanation The interface cannot be selected for the specified protocol because it is already part of
a channel with a different type of protocol enabled. [chars] is the interface.
Recommended Action Remove the interface from the channel group.
Error Message EC-5-ERRPROT3: Command rejected: the interface [chars] is already part
of a channel.
Explanation The interface cannot be unselected for the specified protocol because it is already part
of a channel group. [chars] is the interface.
Recommended Action Remove the interface from the channel group.
Error Message EC-5-L3DONTBNDL1: [chars] suspended: PAgP not enabled on the remote
port.
Explanation PAgP is enabled on the Layer 3 interface, but the partner port is not enabled for PAgP.
In this mode, the port is placed in a suspended state. [chars] is the Layer 3 interface.
Recommended Action Enable PAgP on the remote side by using the channel-group interface
configuration command.
To Next Page
Loading...
