Cisco 7604 - Page 971

A-29
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
Appendix A Online Diagnostic Tests
Exhaustive Memory Tests
TestQoSTcam, page A-30
Note Because the supervisor engine must be rebooted after running memory tests, run memory tests on the
other modules before running them on the supervisor engine. For more information about running
on-demand online diagnostic tests see the
“Configuring On-Demand Online Diagnostics” section on
page 55-3.
TestFibTcamSSRAM
The TestFibTcamSSRAM test checks the FIB TCAM and Layer 3 Adjacency SSRAM memory.
TestAsicMemory
The TestAsicMemory test uses an algorithm to test the memory on a module.
Ta b l e A-51 TestFibTcamSSRAM Test Attributes
Attribute Description
Disruptive/Nondisruptive Disruptive. Disruption is several hours.
Recommendation
Use this test only if you suspect a problem with the hardware
or before putting the hardware into a live network. Do not run
any traffic in the background on the module that you are
testing. The supervisor engine must be rebooted after running
this test.
Default Off.
Release 12.1(20)E, 12.2(14)SX, 12.2(17a)SX.
Corrective action Not applicable.
Hardware support All modules including supervisor engines.
Ta b l e A-52 TestAsicMemory Test Attributes
Attribute Description
Disruptive/Nondisruptive Disruptive. Disruption is approximately one hour.
Recommendation
Use this test only if you suspect a problem with the hardware
or before putting the hardware into a live network. Do not run
any traffic in the background on the module that you are
testing. The supervisor engine must be rebooted after running
this test.
Default Off.
Release 12.2(17a)SX.
Corrective action Not applicable.
Hardware support All modules including supervisor engines.