Index
IN-6
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
configuration and operating state 15
log buffer 16
statistics 16
trust state and rate limit 15
error-disabled state for exceeding rate limit 4
function of 2
interface trust states 3
log buffer
clearing 16
configuring 13, 14
displaying 16
logging of dropped packets, described 5
logging system messages
configuring 14
man-in-the middle attack, described 2
network security issues and interface trust states 3
priority of ARP ACLs and DHCP snooping entries 4
rate limiting of ARP packets
configuring 9
described 4
error-disabled state 4
statistics
clearing 16
displaying 16
validation checks, performing 11
Dynamic Host Configuration Protocol snooping
See DHCP snooping
E
Egress ACL support for remarked DSCP 15
egress ACL support for remarked DSCP 62
egress replication performance improvement 14
Embedded CiscoView 2
enable command 10, 23
enable mode 5
enable sticky secure MAC address 10
enabling
IP MMLS
on router interfaces 11
encapsulation 3
enhanced interface range command 4
environmental monitoring
LED indications 11
SNMP traps 11
supervisor engine and switching modules 12
Syslog messages 11
using CLI commands 10
environment variables
CONFIG_FILE 25
controlling 26
viewing 26
EoMPLS 14
configuring 16
configuring VLAN mode 16
guidelines and restrictions 14
port mode 16
port mode configuration guidelines 19
VLAN mode 16
erase startup-config command
configuration files cleared with 14
ERSPAN 1
EtherChannel
channel-group group
command 8, 12
command example 9
configuration guidelines 5
configuring
Layer 2 8
configuring (tasks) 7
DFC restriction, see CSCdt27074 in the Release Notes
interface port-channel
command example 8
interface port-channel (command) 7
lacp system-priority
command example 10
Layer 2
configuring 8
To Next Page
Loading...
