Index
IN-7
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
OL-4266-08
load balancing
configuring 11
understanding 5
modes 3
PAgP
Understanding 3
port-channel interfaces 5
port-channel load-balance
command 10, 11
command example 11
STP 5
switchport trunk encapsulation dot1q 6
understanding 1
EtherChannel Guard
See STP EtherChannel Guard
EtherChannel Min-Links 12
Ethernet
setting port duplex 14
Ethernet over MPLS (EoMPLS) configuration
EoMPLS port mode 20
EoMPLS VLAN mode 17
examples
configuration
interface 8 to 9
software configuration register 21 to 24
configuring global parameters 3
EXP mutation 4
extended range VLANs 2
See VLANs
extended system ID
MSTP 19
Extensible Authentication Protocol over LAN 1
F
fabric switching mode
See switch fabric module
fabric switching-mode allow dcef-only command on
Supervisor Engine 720
2
fall-back bridging 2
fastethernet 2
fiber-optic, detecting unidirectional links 1
FIB TCAM 3
filters, NDE
destination host filter, specifying 17
destination TCP/UDP port, specifying 17
protocol 18
source host and destination TCP/UDP port 17
Flash memory
configuration process 25
configuring router to boot from 25
loading system image from 24
security precautions 25
write protection 25
Flex Links 1
configuration guidelines 2
configuring 3
default configuration 2
description 1
monitoring 4
flood blocking 1
flow control 13
flow masks
IP MLS
destination-ip 3
destination-source-ip 3
interface-destination-source-ip 3
ip-full 3
ip-interface-full 3
minimum 7
overview 3
flows
IP MMLS
completely and partially switched 4
forward-delay time
MSTP 25
forward-delay time, STP 32
frame distribution