• The current network settings can be cleared by selecting Applications > Admin settings > Reset settings > Network
settings.
Note: The Cisco IP Phone 8861 and 8865 only support a single wireless LAN profile.
802.11r (FT) or CCKM will be negotiated if enabled on the access point when using EAP-FAST, EAP-TLS, PEAP-GTC, or
PEAP-MSCHAPv2, where preference is given to 802.11r (FT).
WEP128 is listed as WEP104 on the Cisco Wireless LAN Controllers.
For more information, refer to the Configuring Settings on the Cisco IP Phone 8800 Series in the
Cisco IP Phone 8800 Series Administration Guide at this URL:
http://www.cisco.com/c/en/us/support/collaboration-endpoints/unified-ip-phone-8800-series/products-maintenance-guides-
list.html
Certificate Management
The Cisco IP Phone 8861 and 8865 can utilize X.509 digital certificates for EAP-TLS or to enable Server Validation when
using PEAP-GTC or PEAP-MSCHAPV2.
A User Certificate and/or Server Certificate can be installed either automatically via Simple Certificate Enrollment Protocol
(SCEP) or manually via the phone’s admin webpage interface (https://x.x.x.x:8443).
Only 1 certificate per certificate type is allowed; 1 User Certificate and 1 Server Certificate.
Once a certificate is installed, Server Validation is automatically enabled if configured for EAP-TLS, PEAP-GTC, or PEAP-
MSCHAPV2.
To Next Page
Loading...
Need help?
General
