Cisco 8861 Deployment Guide

Cisco IP Phone 8861 and 8865 Wireless LAN Deployment Guide
73
To change the TKIP countermeasure holdoff time on the Cisco Wireless LAN Controller, telnet or SSH to the controller and
enter the following command specifying the number of seconds and WLAN ID.
(Cisco Controller) >config wlan security tkip hold-down <nseconds> <wlan-id>
To confirm the change, enter show wlan <WLAN id>, where the following will be displayed.
Tkip MIC Countermeasure Hold-down Timer....... 60
Rogue Policies
It is recommended to use the default value (Disable) for Rogue Location Discovery Protocol.
Cisco Meraki Access Points
When configuring Cisco Meraki access points, use the following guidelines:
• Enable 802.11r for WPA2-Enterprise or Pre-shared key
• Set Splash page to None
• Enable Bridge mode
• Enable VLAN tagging

Cisco 8861 Specifications

General

Resolution	800 x 480 pixels
Audio	Wideband audio
Ethernet Ports	2 x 10/100/1000
Speakerphone	Full-duplex
Display	5-inch color display
Lines	5
PoE	Yes (802.3af)
Protocols	SIP, SDP, SRTP
Wi-Fi	802.11a/b/g/n/ac
Headset Jack	Yes
Codecs	G.711, G.722, G.729, iLBC
USB Port	2 x USB 2.0
USB Ports	2 x USB 2.0
Supported Languages	Multiple (English, French, Spanish, etc.)