Cisco ASR 903 - Page 45

Step 5
Use a ratcheting torque screwdriver to torque the terminal block plug captive screw (above the installed wire lead) from
0.5 Nm (4.425 lbf/sq in) to 0.6 Nm (5.310 lbf/sq in) as shown in the figure.
Figure 20: Torquing the DC Power Supply Terminal Block Plug Screws
Torque is from 0.5 Nm (4.425 lbf/sq in) to 0.6 Nm (5.310
lbf/sq in)
1
Cisco ASR 9000 Series Aggregation Services Router Satellite Systems Installation Guide
45
Installing the Cisco ASR 903 Router as a Satellite Shelf
Installing the DC Power Supply