Cisco ASR 907 User Manual

• Installing the Cisco Microsoft Windows Vista USB Driver
You cannot use the USB port and the EIA port concurrently. See Connecting to the Auxiliary Port.
When the USB port is used it takes priority over the RJ45 EIA port.
Note
The USB Type A-to-Type A cable is not included with the Cisco ASR 907 Router; it is ordered
separately.
Note
Step 2 Connect the end of the cable with the DB-9 connector (or USB Type-A) to the terminal or PC. If your terminal
or PC has a console port that does not accommodate a DB-9 connector, you must provide an appropriate
adapter for that port.
Step 3 To communicate with the router, start a terminal emulator application, such as Microsoft Windows
HyperTerminal. This software should be configured with the following parameters:
• 9600 baud
• 8 data bits
• no parity
• 1 stop-bit
• no flow control
Cisco ASR 907 Router Hardware Installation Guide
94
Installing the Cisco ASR 907 Router
Connecting to the Serial Port using Microsoft Windows

Cisco ASR 907 Specifications

General

Brand	Cisco
Model	ASR 907
Category	Network Router
Language	English