CHAPTER 2
Preparing for Installation
The following sections describe how to prepare for the installation of the Cisco ASR 907 Router at your site:
• Safety Guidelines, on page 31
• Site Planning, on page 39
• Receiving the Cisco ASR 907 Router, on page 50
Safety Guidelines
Before you begin the installation of the Cisco ASR 907 Router, review the safety guidelines in this chapter
to avoid injuring yourself or damaging the equipment.
In addition, before replacing, configuring, or maintaining the Cisco ASR 907 Router, review the safety
warnings listed in Regulatory Compliance and Safety Information for the Cisco ASR 900 Series Aggregation
Routers.
Standard Warning Statements
To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance and
Safety Information document that accompanied this device.
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety: This unit
should be mounted at the bottom of the rack if it is the only unit in the rack. When mounting this unit in a
partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of
the rack. If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing
the unit in the rack. Statement 1006
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed only
through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
Cisco ASR 907 Router Hardware Installation Guide
31
To Next Page
Loading...
Need help?
General
