Cisco ASR 907 User Manual

Temperature Sensor
The Cisco ASR 907 Router has a temperature sensor to detect ambient overtemperature conditions inside the
chassis. The operating temperature range is between –40 C to +65 C. Temperatures outside this range are
reported to the processor as an interrupt, and the software takes action to generate the appropriate alarms.
Interface Numbering
Following is an explanation of the slot or port numbering:
• The numbering format is Interface type slot or interface number. Interface (port) numbers begin at
logical 0 for each interface type.
• Interface module slots are numbered from bottom to top, with logical interfaces on each module numbered
from left to right. Interfaces are hard-wired. Therefore, port 0 is always logical interface 0/0, port 1 is
always logical interface 0/1, and so on.
Following is the A900-RSP4 port numbering:
• For IM N560-IMA2C the port numbering is HundredGigE — 0/0/0/0 - 0/0/0/1
• For IM A900-IMA8Z the port numbering is TenGigE — 0/0/0/1 - 0/0/0/7
• For IM A900-IMA8CS1Z-M the port numbering is:
• GigE — 0/0/0/0 - 0/0/0/15
• TenGigE — 0/0/0
6
/16
The following commands display the active RP slot number. The interface module is referenced as 1/x instead
of 0/x:
• show diag all eeprom detail
• show platform software trace message iomd
• show platform software agent iomd
• show platform software peer shell-manager brief
• show platform software peer chassis-manager
• show platform software memory iomd
• set platform software trace iomd
Regulatory Compliance
For regulatory compliance and safety information, see the Regulatory Compliance and Safety Information
for the Cisco ASR_900 Series Aggregation Routers document.
6
Slot 0 is not supported in A900-IMA8CS1Z-M
Cisco ASR 907 Router Hardware Installation Guide
29
Cisco ASR 907 Router Overview
Temperature Sensor

Cisco ASR 907 Specifications

General

Brand	Cisco
Model	ASR 907
Category	Network Router
Language	English