Cisco ASR 907 User Manual

Connecting to the Auxiliary Port 99
Connecting a Management Ethernet Cable 101
Installing and Removing SFP and XFP Modules 101
Connecting a USB Flash Device 101
Removing a USB Flash Device 102
Connecting Timing Cables 102
Connecting Cables to the BITS Interface 102
Connecting Cables to a GNSS Interface 103
Connecting a Cable to the GNSS Antenna Interface 104
Connecting Ethernet Cables 105
Connecting Cables to SFP Modules 106
Connecting T1/E1 Cables 106
Installing the Cable Connectors 106
T1/E1 Pinouts 109
RJ45 Cable Pinouts 109
RJ48 Cable Pinouts 109
Connecting Cables to the Patch Panel 109
Patch Panel Pinout 110
Patch Panel Cabling for Redundancy 110
Recommended Patch Panel 112
Installing Patch Panel 113
Install 3G Patch Panel 117
Install Rack Brackets 118
Set up 3G Patch Panel on Rack 125
Wall Mount 3G Patch Panel 137
Patch Panel Dimensions 139
Connecting Serial Cables 144
Connecting the Fan Tray Alarm Port 145
Connector and Cable Specifications 146
Cisco Router Initial Configuration 147
CHAPTER 4
Checking Conditions Prior to System Startup 147
Powering Up the Cisco ASR 907 Router 148
Verifying the Front Panel LEDs 150
Cisco ASR 907 Router Hardware Installation Guide
vii
Contents

Cisco ASR 907 Specifications

General

Brand	Cisco
Model	ASR 907
Category	Network Router
Language	English