Cisco C20 Administrator's Guide

14
Cisco TelePresence System Quick Set C20 / C20 Plus and Profiles using C20 Administrator guide
D14637.04 Profile C20 and Quick Set C20 Administrator Guide TC4.0, November 2010.
Copyright © 2010 Cisco Systems, Inc. All rights reserved.
www.cisco.com
The Snapshot page
Making a snapshot
When administrating the video system from a
remote location, you can use the web interface
snapshot feature to check the view of the main
video input source.
This feature is disabled by default. The feature
can be enabled only when you have direct
access to the codec, i.e. from the on screen
menu or by using the command line interface
via the codec serial data port.
Using the on screen menu
From the Advanced configuration menu,
navigate to Video > AllowWebSnapshots and
select On to enable the snapshot feature.
Using the command line interface
Enter the following command to enable the
snapshot feature:
xConguration Video
AllowWebSnapshots <Off/On>.
How to make a snapshot
1. Press Get snapshot. The
snapshot will be displayed on
the web interface.
Contents
Contact us
Web interface
Advanced configuration
Introduction
Password protection
Appendices
Web interface

Cisco C20 Specifications

General

Encryption	AES
Frame Rate	Up to 30 fps
Firewall Traversal	Yes
Connectivity	Wired
Video Standards	H.264
Audio Standards	G.711, G.722
Network Interfaces	10/100/1000 Ethernet
Content Sharing	Yes
Product Type	Video conferencing system
Network Protocols	H.323, SIP
Interfaces	Ethernet
Video Resolution	720p