20
Cisco TelePresence System Quick Set C20 / C20 Plus and Profiles using C20 Administrator guide
D14637.04 Profile C20 and Quick Set C20 Administrator Guide TC4.0, November 2010.
Copyright © 2010 Cisco Systems, Inc. All rights reserved.
www.cisco.com
The Audit Certificate page
Audit certificate
The list of trusted audit certificates is a list
containing all audit servers that your codec
trusts.
If the audit logging mode is set to
ExternalSecure (see below), the audit logging
information will only be sent to entities holding
a valid audit certificate.
About audit logging
Audit logging records all login activity and
configuration changes on the codec.
Audit logging is disabled by default, and must
be enabled using the on screen menu, the web
interface or the command line interface.
There are three audit logging modes: Internal,
External and ExternalSecure.
See the Administrator guide for your product
for more information about audit logging.
Enable secure audit logging
NOTE: You should upload the audit certificate
list before enabling secure audit logging.
To enable secure audit logging using the web
interface or on screen menu, go to Advanced
Configuration and perform the following steps:
1. Navigate to Security > Audit > Server and
enter the IP address of the audit server.
2. Navigate to Security > Audit > Logging >
Mode and set it to ExternalSecure.
To enable secure audit logging using the
command line interface, log in to the codec
using SSH or Telnet and enter the following
commands:
1. xConguration Security Audit
Server Address <ip address>
2. xConguration Security Audit
Logging Mode ExternalSecure
Uploading the Audit certificate list
To install the audit certificate, you will need:
• Audit list file ( .PEM format)
Contact your system administrator to obtain the required file.
• Press Browse... and locate the file with the audit list file (.PEM
format).
• Press Upload to upload the certificate to the codec.
To Next Page
Loading...
Need help?
General
