33
Cisco TelePresence System Quick Set C20 / C20 Plus and Profiles using C20 Administrator guide
D14637.04 Profile C20 and Quick Set C20 Administrator Guide TC4.0, November 2010.
Copyright © 2010 Cisco Systems, Inc. All rights reserved.
www.cisco.com
H323 Profile [1..1] Authentication Mode
Set the authenticatin mode for the H.323 profile.
Requires user role: ADMIN
Value space: <On/Off>
On: If the H.323 Gatekeeper Authentication Mode is set to On and a H.323 Gatekeeper indicates that
it requires authentication, the system will try to authenticate itself to the gatekeeper. NOTE: Requires
the Authentication LoginName and Authentication Password to be defined on both the codec and
the Gatekeeper.
Off: If the H.323 Gatekeeper Authentication Mode is set to Off the system will not try to authenticate
itself to a H.323 Gatekeeper, but will still try a normal registration.
Example: xConguration H323 Prole 1 Authentication Mode: Off
Network [1..1] Speed
Set the Ethernet link speed.
Requires user role: ADMIN
Value space: < Auto/10half/10full/100half/100full/1000full>
Auto: Autonegotiate link speed.
10half: Force link to 10Mbps half-duplex.
10full: Force link to 10Mbps full-duplex.
100half: Force link to 100Mbps half-duplex.
100full: Force link to 100Mbps full-duplex.
1000full: Force link to 1Gbps full-duplex.
Example: xConguration Network 1 Speed: Auto
Network [1..1] Assignment
Define whether to use DHCP or Static IPv4 assignment.
Requires user role: ADMIN
Value space: <Static/DHCP>
Static: Set the network assignment to Static and configure the static IPv4 settings (IP Address,
SubnetMask and Gateway).
DHCP: The system addresses are automatically assigned by the DHCP server.
Example: xConguration Network 1 Assignment: DHCP
Network [1..1] IPStack
Select which internet protocols the system will support.
Requires user role: ADMIN
Value space: <IPv4/IPv6>
IPv4: IP version 4 is supported.
IPv6: IP version 6 is supported. The IPv4 settings (IP Address, IP Subnet Mask and Gateway) will be
disabled.
Example: xConguration Network 1 IPStack: IPv4
Network [1..1] MTU
Set the Ethernet MTU (Maximum Transmission Unit).
Requires user role: ADMIN
Value space: <400..1500>
Range: Select a value from 400 to 1500 bytes.
Example: xConguration Network 1 MTU: 1500
The Network settingsThe H323 Profile settings, continued...