Cisco Catalyst 250 Series Configuration Guide

PurposeCommand or Action
• power inline police action log—Generates a syslog message
while still providing power to the port.
If you do not enter the action log keywords, the default action shuts
down the port and puts the port in the error-disabled state.
Returns to global configuration mode.exit
Example:
Switch(config-if)# exit
Step 4
(Optional) Enables error recovery from the PoE error-disabled state,
and configures the PoE recover mechanism variables.
Use one of the following:
Step 5
•
errdisable detect cause inline-power
By default, the recovery interval is 300 seconds.
•
errdisable recovery cause inline-power
For interval interval, specifies the time in seconds to recover from the
error-disabled state. The range is 30 to 86400.
•
errdisable recovery interval interval
Example:
Switch(config)# errdisable detect cause
inline-power
Switch(config)# errdisable recovery cause
inline-power
Switch(config)# errdisable recovery
interval 100
Returns to privileged EXEC mode.exit
Example:
Switch(config)# exit
Step 6
Displays the power monitoring status, and verify the error recovery
settings.
Use one of the following:
Step 7
•
show power inline police
•
show errdisable recovery
Example:
Switch# show power inline police
Switch# show errdisable recovery
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
94 OL-29420-01
Configuring PoE
Configuring Power Policing

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English