This example shows how to configure the voice application type for the native VLAN with priority tagging:
Switchconfig-network-policy)# voice vlan dot1p cos 4
Switchconfig-network-policy)# voice vlan dot1p dscp 34
Monitoring and Maintaining LLDP, LLDP-MED, and Wired
Location Service
Commands for monitoring and maintaining LLDP, LLDP-MED, and wired location service.
DescriptionCommand
Resets the traffic counters to zero.clear lldp counters
Deletes the LLDP neighbor information table.clear lldp table
Clears the NMSP statistic counters.clear nmsp statistics
Displays global information, such as frequency of
transmissions, the holdtime for packets being sent,
and the delay time before LLDP initializes on an
interface.
show lldp
Displays information about a specific neighbor.
You can enter an asterisk (*) to display all neighbors,
or you can enter the neighbor name.
show lldp entry entry-name
Displays information about interfaces with LLDP
enabled.
You can limit the display to a specific interface.
show lldp interface [interface-id]
Displays information about neighbors, including
device type, interface type and number, holdtime
settings, capabilities, and port ID.
You can limit the display to neighbors of a specific
interface or expand the display for more detailed
information.
show lldp neighbors [interface-id] [detail]
Displays LLDP counters, including the number of
packets sent and received, number of packets
discarded, and number of unrecognized TLVs.
show lldp traffic
Displays the location information for the specified
administrative tag or site.
show location admin-tag string
Displays the location information for a specific global
civic location.
show location civic-location identifier id
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
70 OL-29420-01
Configuring LLDP, LLDP-MED, and Wired Location Service
Monitoring and Maintaining LLDP, LLDP-MED, and Wired Location Service
To Next Page
Loading...
Need help?
General