EasyManuals Logo

Cisco Catalyst 250 Series Configuration Guide

Cisco Catalyst 250 Series
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
Configuring SVI Autostate Exclude
SUMMARY STEPS
1.
configure terminal
2.
interface interface-id
3.
switchport autostate exclude
4.
end
5.
show running config interface interface-id
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Specifies a Layer 2 interface (physical port or port channel),
and enter interface configuration mode.
interface interface-id
Example:
Switch(config)# interface gigabitethernet1/0/2
Step 2
Excludes the access or trunk port when defining the status
of an SVI line state (up or down)
switchport autostate exclude
Example:
Switch(config-if)# switchport autostate
Step 3
exclude
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 4
(Optional) Shows the running configuration.
show running config interface interface-id
Step 5
Verifies the configuration.
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29420-01 33
Configuring Interface Characteristics
Configuring SVI Autostate Exclude

Table of Contents

Other manuals for Cisco Catalyst 250 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 250 Series and is the answer not in the manual?

Cisco Catalyst 250 Series Specifications

General IconGeneral
BrandCisco
ModelCatalyst 250 Series
CategorySwitch
LanguageEnglish

Related product manuals