Cisco Catalyst 250 Series Configuration Guide

Default EEE Configuration
EEE is disabled by default.
Restrictions for EEE
EEE has the following restrictions:
•
Changing the EEE configuration resets the interface because the device has to restart Layer 1
autonegotiation.
•
You might want to enable the Link Layer Discovery Protocol (LLDP) for devices that require longer
wakeup times before they are able to accept data on their receive paths. Doing so enables the device to
negotiate for extended system wakeup times from the transmitting link partner.
How to Configure EEE
You can enable or disable EEE on an interface that is connected to an EEE-capable link partner.
Enabling or Disabling EEE
SUMMARY STEPS
1.
configure terminal
2.
interface interface-id
3.
power efficient-ethernet auto
4.
no power efficient-ethernet auto
5.
end
6.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
98 OL-29420-01
Configuring EEE
Default EEE Configuration

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English