Cisco Catalyst 250 Series Configuration Guide

you can apply a network-policy profile on the interface. This way the interface has the voice or
voice-signaling VLAN network-policy profile applied on the interface.
•
You cannot configure static secure MAC addresses on an interface that has a network-policy profile.
•
You cannot configure a network-policy profile on a private-VLAN port.
•
For wired location to function, you must first enter the ip device tracking global configuration command.
How to Configure LLDP, LLDP-MED, and Wired Location Service
Enabling LLDP
Beginning in privileged EXEC mode, follow these steps to enable LLDP:
SUMMARY STEPS
1.
configure terminal
2.
lldp run
3.
interface interface-id
4.
lldp transmit
5.
lldp receive
6.
end
7.
show lldp
8.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Enables LLDP globally on the switch.lldp run
Example:
Switch (config)# lldp run
Step 2
Specifies the interface on which you are enabling
LLDP, and enter interface configuration mode.
interface interface-id
Example:
Switch (config)# interface
Step 3
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
58 OL-29420-01
Configuring LLDP, LLDP-MED, and Wired Location Service
How to Configure LLDP, LLDP-MED, and Wired Location Service

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English