EasyManuals Logo

Cisco Catalyst 250 Series Configuration Guide

Cisco Catalyst 250 Series
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
PurposeCommand or Action
to not negotiate if connected to a device that does not support
autonegotiation.
This command is not available on a 10-Gigabit Ethernet interface.duplex {auto | full | half}
Step 4
Example:
Switch(config-if)# duplex half
Enter the duplex parameter for the interface.
Enable half-duplex mode (for interfaces operating only at 10 or 100 Mb/s).
You cannot configure half-duplex mode for interfaces operating at 1000
Mb/s.
You can configure the duplex setting when the speed is set to auto.
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 5
Displays the interface speed and duplex mode configuration.
show interfaces interface-id
Example:
Switch# show interfaces
Step 6
gigabitethernet1/0/3
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 7
startup-config
Configuring IEEE 802.3x Flow Control
SUMMARY STEPS
1.
configure terminal
2.
interface interface-id
3.
flowcontrol {receive} {on | off | desired}
4.
end
5.
show interfaces interface-id
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
30 OL-29420-01
Configuring Interface Characteristics
Configuring IEEE 802.3x Flow Control

Table of Contents

Other manuals for Cisco Catalyst 250 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 250 Series and is the answer not in the manual?

Cisco Catalyst 250 Series Specifications

General IconGeneral
BrandCisco
ModelCatalyst 250 Series
CategorySwitch
LanguageEnglish

Related product manuals