Cisco Catalyst 250 Series Configuration Guide

•
IP address
•
802.1X username if applicable
•
Device category is specified as a wired station
•
State is specified as delete
•
Serial number, UDI
•
Time in seconds since the switch detected the disassociation
When the switch shuts down, it sends an attachment notification with the state delete and the IP address before
closing the NMSP connection to the MSE. The MSE interprets this notification as disassociation for all the
wired clients associated with the switch.
If you change a location address on the switch, the switch sends an NMSP location notification message that
identifies the affected ports and the changed address information.
Default LLDP Configuration
Table 8: Default LLDP Configuration
Default SettingFeature
DisabledLLDP global state
120 secondsLLDP holdtime (before discarding)
30 secondsLLDP timer (packet update frequency)
2 secondsLLDP reinitialization delay
Disabled to send and receive all TLVsLLDP tlv-select
DisabledLLDP interface state
DisabledLLDP receive
DisabledLLDP transmit
Disabled to send all LLDP-MED TLVs. When LLDP is globally
enabled, LLDP-MED-TLV is also enabled.
LLDP med-tlv-select
Configuration Guidelines
•
If the interface is configured as a tunnel port, LLDP is automatically disabled.
•
If you first configure a network-policy profile on an interface, you cannot apply the switchport voice
vlan command on the interface. If the switchport voice vlan vlan-id is already configured on an interface,
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29420-01 57
Configuring LLDP, LLDP-MED, and Wired Location Service
Default LLDP Configuration

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English