Cisco Catalyst 250 Series Configuration Guide

CHAPTER 2
Configuring Interface Characteristics
•
Finding Feature Information, page 13
•
Information About Configuring Interface Characteristics, page 13
•
How to Configure Interface Characteristics, page 24
•
Monitoring Interface Characteristics, page 37
•
Configuration Examples for Interface Characteristics, page 38
•
Additional References for the Interface Characteristics Feature, page 41
•
Feature History and Information for Configuring Interface Characteristics, page 42
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Information About Configuring Interface Characteristics
Interface Types
This section describes the different types of interfaces supported by the switch. The rest of the chapter describes
configuration procedures for physical interface characteristics.
The stack ports on the rear of the stacking-capable switches are not Ethernet ports and cannot be configured.Note
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29420-01 13

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English