Monitoring Power Status
Table 13: Show Commands for Power Status
PurposeCommand
(Optional) Displays the status of the internal power
supplies for each switch in the stack or for the
specified switch. The range is 1 to 8, depending on
the switch member numbers in the stack.
These keywords are available only on
stacking-capable switches.
show env power switch [switch-number]
Displays PoE status for a switch or switch stack, for
an interface, or for a specific switch in the stack.
show power inline [interface-id | module
switch-number]
Displays the power consumption data.show power inline consumption
Displays the power policing data.show power inline police
Configuration Examples for Configuring PoE
Budgeting Power: Example
When you enter one of the following commands,
•
[no] power inline consumption default wattage global configuration command
•
[no] power inline consumption wattage
interface configuration command
this caution message appears:
%CAUTION: Interface Gi1/0/1: Misconfiguring the 'power inline consumption/allocation'
command may cause damage to the
switch and void your warranty. Take precaution not to oversubscribe the power supply. It
is recommended to enable power
policing if the switch supports it. Refer to documentation.
Feature Information for PoE
ModificationRelease
This feature was introduced.Cisco IOS 15.0(2)EX1
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29420-01 95
Configuring PoE
Monitoring Power Status
To Next Page
Loading...
Need help?
General