Cisco Catalyst 250 Series Configuration Guide

SUMMARY STEPS
1.
configure terminal
2.
lldp holdtime seconds
3.
lldp reinit delay
4.
lldp timer rate
5.
lldp tlv-select
6.
interface interface-id
7.
lldp med-tlv-select
8.
end
9.
show lldp
10.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
(Optional) Specifies the amount of time a receiving device
should hold the information from your device before discarding
it.
lldp holdtime seconds
Example:
Switch(config)# lldp holdtime 120
Step 2
The range is 0 to 65535 seconds; the default is 120 seconds.
(Optional) Specifies the delay time in seconds for LLDP to
initialize on an interface.
lldp reinit delay
Example:
Switch(config)# lldp reinit 2
Step 3
The range is 2 to 5 seconds; the default is 2 seconds.
(Optional) Sets the sending frequency of LLDP updates in
seconds.
lldp timer rate
Example:
Switch(config)# lldp timer 30
Step 4
The range is 5 to 65534 seconds; the default is 30 seconds.
(Optional) Specifies the LLDP TLVs to send or receive.lldp tlv-select
Example:
Switch(config)# tlv-select
Step 5
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
60 OL-29420-01
Configuring LLDP, LLDP-MED, and Wired Location Service
Configuring LLDP Characteristics

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English