Cisco Catalyst 250 Series Configuration Guide

DescriptionLLDP-MED TLV
LLDP-MED location TLVlocation
LLDP-MED network policy TLVnetwork-policy
LLDP-MED power management TLVpower-management
Beginning in privileged EXEC mode, follow these steps to enable a TLV on an interface:
SUMMARY STEPS
1.
configure terminal
2.
interface interface-id
3.
lldp med-tlv-select
4.
end
5.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Specifies the interface on which you are configuring
an LLDP-MED TLV, and enter interface configuration
mode.
interface interface-id
Example:
Switch(config)# interface
Step 2
gigabitethernet2/0/1
Specifies the TLV to enable.lldp med-tlv-select
Example:
Switch(config-if)# lldp med-tlv-select
Step 3
inventory management
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 4
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
62 OL-29420-01
Configuring LLDP, LLDP-MED, and Wired Location Service
Configuring LLDP-MED TLVs

Cisco Catalyst 250 Series Specifications

General

Brand	Cisco
Model	Catalyst 250 Series
Category	Switch
Language	English